Peridoser Tubing

The Peridoser pump tubing will need replacing approximately every 18 months - 2 years to ensure reliable performance. This is easy to replace and no other types of tubing should be used.

Tube Lube

The tube lube is required for lubricating the tubing every six months and when replacing the tubing.

Sample Board

This is a chamber where the probes are placed in a Dosetronic dosing system to keep them safe from damage and allow for easy cleaning and calibration.

Fittings Kit

The fittings kit forms part of the Complete Dosetronic Kit. It contains all the hosing and fittings required for easy installation from the Peridosers to the stock solution tanks.

Replaceable pH Probe Cell

The replacement probe cell for the pH Truncheon. This is supplied in kit form and comes with the probe cell, Contact Ring pack, spare oring, spare storage cap and pH probe cleaning tool.

Contact Ring Folder

Replaceable Contact Rings for the pH Truncheon.

pH Probe Cleaning Tool

An easy to use and very effective tool for cleaning all Bluelab pH probe glassware.

pH Probe Wetting Cap

It is essential that the wetting cap is placed back on the probe tip of the pH Probe after use and when being stored. If it drys it dies! A small amount of clean water or pH4.0 solution placed into the cap helps keep the probe tip moist.

pH Truncheon Storage Cap

pH Probes must be kept moist at all times. This is especially important when the instrument is not in use. The sponge inside the cap is kept moist with clean water or pH4.0 solution and must be placed back on the pH Truncheon when not in use.

Batteries (AA + AAA)

Super Heavy Duty batteries for use in all Bluelab Meters.